Voopoo ITO Replacement Coils ITO M0/M1/M2/M3 for Voopoo Doric 20 Kit & Voopoo Drag Q Kit - 5 Pack

Voopoo ITO Replacement Coils

Coils for the ITO platform - the fitting Voopoo use across the smaller Doric and Argus pods. All four are mesh, and the range is deliberately weighted towards mouth-to-lung: three of the four are 0.7Ω or higher, which is what most people coming off cigarettes actually want.

Key Features:

• Fits the ITO platform - Doric and Argus pod kits

• Four mesh resistances from 0.5Ω to 1.2Ω

• Weighted towards MTL and nic salts

• Press-fit into the ITO cartridge

• Sold in packs of five

Coil Options & Specifications:

• ITO-M3 1.2Ω Mesh: 8–12W, the tightest, and the one for 20mg nic salts

• ITO-M2 1.0Ω Mesh: 10–14W, a fraction warmer than the M3, still cigarette-like

• ITO-M1 0.7Ω Mesh: 14–18W, the middle of the range, and better on 10mg than 20mg

• ITO-M0 0.5Ω Mesh: 18–25W, the loosest and warmest - high VG at 3mg or 6mg

Fits:

Voopoo Doric 20, Doric E, Drag Q, Argus P1, Argus G, Argus A, Argus Pod, Argus Pod SE and Argus Z.

Package Contents:

• 5 x Voopoo ITO Replacement Coils

Before You Buy:
ITO is not the same platform as PnP. Voopoo run both, and the small Doric and Argus pods take ITO while the Drag and Vinci take PnP. Our coil finder will tell you which from the device name.

Pick by nicotine as much as by device: the 1.0Ω and 1.2Ω suit 20mg salts, the 0.5Ω wants high-VG liquid at a low strength.